Home/Support/Support Forum/IMX28 problem permanently bridging eth0 and eth1
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

IMX28 problem permanently bridging eth0 and eth1

0 votes
Using the example provided in the application note Network Bridging in the Digi Embedded Linux Command Line Reference Manual, I am able to successfully bridge 2 network segments.

Problem: when one of the cables is disconnected, the bridge does not recover until an ifconfig ethn up command is issued on the relevant port. Is there a way of making this recover automatically?

I am creating the bridge in a startup script rather than the normal linux configuration files - is this the problem? I have done this because simply adding the bridge to /etc/network/interfaces does nothing, even when /etc/network/if-up.d/ifup is modified to parse the correct configuration.

Thanks for any suggestions.

Neil
asked Aug 18, 2014 in Linux by neilh New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Have you tested the same on the Linux PC - I'm afraid you'd see the same result.

as a workaround you could use a netlink daemon to monitor the link and bring the bridge up
answered Aug 26, 2014 by LeonidM Veteran of the Digi Community (2,789 points)
...