Home/Support/Support Forum/chose the wrong Function Set to "ZIGBEE ROUTER/END DEVICE SENSOR"
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

chose the wrong Function Set to "ZIGBEE ROUTER/END DEVICE SENSOR"

0 votes
When I program the XBee Pro by using XCTU, chose the wrong Function Set to "ZIGBEE ROUTER/END DEVICE SENSOR" cause now I cannot get any serial communication with the XCTU, please help how I can get back the chip with the communication. Thanks!
asked Aug 19, 2014 in IEEE 802.15.4 by stephen New to the Community (0 points)
Have you found any solution? I have the same problem.
commented Jun 1, 2015 by stefan1221 New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
Try following the steps described at https://www.youtube.com/watch?v=fxOqQZD-oaM to reload your firmware files with.
answered Aug 19, 2014 by mvut Veteran of the Digi Community (15,111 points)
facing the same problem, but it doesn't work
asked Apr 21, 2015 in IEEE 802.15.4 by poptoplcy New to the Community (0 points)
...