Home/Support/Support Forum/i.mx53 TV-Out with Yocto 1.4.1
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

i.mx53 TV-Out with Yocto 1.4.1

0 votes
I am now trying for some time the TV out (PAL) to activate in Yocto. Unfortunately, without success. Is there a guide or an idea how this could be done?
I've tried various parameters in the bootloader (setenv video ......), VGA and LCD function properly, but I need a composite video output.
Thanks in advance for the help

regards

Christian
asked Sep 2, 2014 in Linux by Christian Scherer New to the Community (2 points)

Please log in or register to answer this question.

4 Answers

0 votes
how is your TV connected to the development board?
answered Sep 2, 2014 by LeonidM Veteran of the Digi Community (3,556 points)
0 votes
And are you having SBC or EA kit?
answered Sep 2, 2014 by tuxembb Veteran of the Digi Community (288 points)
0 votes
thank you for your questions. I use at the moment a JSK to test purposes.
As I understand the whole thing would have to at TVE, depending on the mode, the corresponding signal to the VGA connector to be tapped. The TV_OUT_MODE-5 (Y / C and CVBS) I would prefer since then would have to the VGA connector on Green Y, Red in C, and CVBS blue bear.
The only question is: How do I get back with the Yocto?
What startup parameters I have to give to the U-BOOT?
Do I need to adjust something in the kernel?
With VGA, the thing runs flawlessly ...

Thank you for your support.

regards,

Christian
answered Sep 3, 2014 by Christian Scherer New to the Community (2 points)
0 votes
i.mx53 SoC has a television encoder (TVE) which can operate in two modes, VGA or TV standards. Digi only supports VGA on DEL/DEY. Digi can offer design services support to implement the feature.
answered Sep 3, 2014 by LeonidM Veteran of the Digi Community (3,556 points)
...