I want to set up change detect on my series 2 xbees but cannot get it to work.
I have followed these instructions: http://www.digi.com/support/kbase/kbaseresultdetl?id=2188
Both radios are talking to each other but I cannot find the Tn command in XCTU. Would not setting this stop it from working altogether? Where would I find this parameter in XCTU?
I have set the detecting xbee (Zigbee Router AT) to IR50 and IC18 and have a button on DIO3 (D3=3)
The receiving Xbee (Zigbee Coordinator API) is set to D3 = 4 to which I have attached a LED
When using the XCTU terminal I can see that the button press on the remote xbee is having an effect on the xbee hooked up to my computer. However, when I put the receiving xbee back in the circuit the button press has no effect.
Any help would be very much appreciated, thanks.