Home/Support/Support Forum/DIO Line Passing question

DIO Line Passing question

0 votes
Hi.
I'm want to assure if is possible using the XBee 802.15.4 DIO lines to off an attached sensor using a transistor based circuit. The XBee is using RS-232 interface to connect to the sensor and I look that maybe I can use RTS pin to control a high and low line passing. I'm not want the answer about how to do it, but rather I want to assure if I can reach that using DIO lines passing.
asked Sep 16, 2014 in RF Solutions and XBee by progloverfan New to the Community (17 points)

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
Sure you can use that line via DIO line passing. Just understand that it is a GPIO line and what ever line you use as an input on one side must be an output on the other.
answered Sep 16, 2014 by mvut Veteran of the Digi Community (11,302 points)
selected Sep 16, 2014 by progloverfan
...