Home/Support/Support Forum/Adding a S2B Pro to X-CTU, It asks me to 'Reset' the board. Pins 5 & 10 don't reset!
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Adding a S2B Pro to X-CTU, It asks me to 'Reset' the board. Pins 5 & 10 don't reset!

0 votes
I have a USB extender, so i short 'Reset' & 'GND' together and this wont rest anything.

So I try and short pin 5 on top of the board (rather that use the USB breakout connections) and pin 10 and it still wont reset or let me add a radio?

I have 3 radios and all of them wont reset when i am asked too!

All baud rates are set as default (9600) and i know the board works as the recovery tool can upload a firmware but i just cant get it to reset?

Any Help?

Thank-You


EDIT -

I have tried holding the short for 10 seconds and nothing, also just touching wont reset either!

Just something so simple is holding me back!
asked Oct 10, 2014 in USB Serial by Cosha New to the Community (0 points)

Please log in or register to answer this question.

...