Home/Support/Support Forum/I need help with analog data between two Series One XBee Pros.

I need help with analog data between two Series One XBee Pros.

0 votes
I have two Series One XBees talking to each other "directly"; --switches on one, LEDs on the other. When DI0 on transmitter is made analog the output on the receiver’s pin 7 (RSSI) shows a pulse width modulated signal, but it randomly changes value. It alternates about one per second which is in sync with an LED blink on pin 3 (receiver).
asked Oct 12, 2014 in Interface/Development Boards by Walter Clark New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
You need to change the RSSI to PWM for output. That is done with the P0 command.
answered Oct 30, 2014 by mvut Veteran of the Digi Community (11,302 points)
...