Home/Support/Support Forum/How to configure XBEE S2 module in direct mode for remote digital input?

How to configure XBEE S2 module in direct mode for remote digital input?

0 votes
Hello!
I am using two XB24-Z7WIT-004 modules. one as API
coordinator and other as AT router. I want to check the status of switch attached to coordinator and show corresponding status on led attached to corresponding pin of router.
I want to know configuration parameters needs to be set and their values?
Thank you
asked Oct 29, 2014 in IEEE 802.15.4 by Junaid2216 New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
Try using the IC command to tell the system to monitor the line in question.
answered Oct 29, 2014 by mvut Veteran of the Digi Community (15,410 points)
0 votes
I ALSO HAVE SAME PROBLEM BUT WHAT I AM GETTING IS

SET ONE AS CORDINATOR API MODE
OTHER AS ROUTER AT MODE

SET THEIR ADRESSES CROS IN DH AND DL.

MAKE FRAME 17(REMOTE AT MODE) SET ADDRESS OF REMOTE RADIO AND AT COMMAND LIKE D0,D1,D2 FOR DIFFERENT PIN.

PARAMETER VALUE 01,02,03,04,05 AS YOUR REQUIERMENT.


YOU WILL RECIEVE PACKET BUT CAN`T CHANGE STATE.
answered Sep 11, 2016 by baraiyanirav2225 New to the Community (4 points)
...