Home/Support/Support Forum/How to flash code in XBee 868/865 lp module using codewarrior
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How to flash code in XBee 868/865 lp module using codewarrior

0 votes
Respected sir,
I have xbee 868/865 lp module. My device are programmable. I use codewarrior 10.2 with xbee SDK. When i debug / release Xbee sample application project code after that I run that code. I follow all the instruction which is give in help, I perform all the step and i got no error or warning and also generate mc9s08qe32.tcl but i show that xbee device can not perform anything.

I execute blink LED code from Xbee sample application project but i got no error or warning and also generate mc9s08qe32.tcl but my xbee device LED can not blink.

Please give solution about my problem. I can not understand it please give me solution.

THANKS
related to an answer for: Programming Xbee with FTDI Cable - how to get CodeWarrior to talk to Xbee without adapter?
asked Nov 2, 2014 in XBee Programmable Development by Dhruval New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
have you checked to make sure that the RF processor's UART is at 115.2kbps and API mode is enabled?
answered Nov 11, 2014 by mvut Veteran of the Digi Community (15,223 points)
Thanks you so much sir for give me reply

Sir,I have xbee 868/865 lp module in that Freescale 8-bit MC9S08QE32 MCU. I checked and i sure that RF processor's UART is at 115.2 kbps and also my device in API Mode but still I got the "Power Cycle Dialog" error are display. Please Sir give me solution about my problem.
commented Nov 12, 2014 by Dhruval New to the Community (0 points)
What do you mean by "Power Cycling Dialog"? What program are you getting this in and what steps are you taking to produce it?
commented Nov 12, 2014 by mvut Veteran of the Digi Community (15,223 points)
Freescale 8-bit MC9S08QE32 having 32 KB flash memory in my Xbee 865/868 LP module.

I have use directly use sample code of give in CodeWarrior  10.2 with XBEE SDK . I am select  "Xbee sample application project "  in that next select my device Xbee 865/868 lp S8 module next  i have have to select GPIOs project in that i have select blink_led project. Then i have to build that project. After that i have go to run configure then in  connection type  i have select  "P & E HSS08 Multilink \ Multilink Universal \ Cyclone Pro \ OSBDM " then i run that project but i got "POWER CYCLE DIALOG"  after click ok then i get this window "p&e connection " .

How to solve this "POWER CYCLE DIALOG" error.
commented Nov 13, 2014 by Dhruval New to the Community (0 points)
Sounds like you need to reinstall the Code Warrior and SDK with the P&E micro connected to the PC.
commented Nov 13, 2014 by mvut Veteran of the Digi Community (15,223 points)
...