Home/Support/Support Forum/Can i configure Xbee parameters using arduino code?

Can i configure Xbee parameters using arduino code?

+1 vote
Hi, so i'm looking into the possibility of creating a subroutine in arduinoC that configures the parameters of an Xbee S1 module (such as Channel and PANID), I want to do this because i want to automate the process of setting up new Xbee modules introduced to my network rather having to plug them into a pc and configuring them using XCTU.

Is this possible?
asked Nov 2, 2014 in IEEE 802.15.4 by BlackPCB New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

+1 vote
Sure. Any setting that can be set in XCTU can be set using the associated AT command and parameter value.
answered Nov 12, 2014 by mvut Veteran of the Digi Community (15,223 points)
...