Home/Support/Support Forum/Power usage of programmable xBee is high

Power usage of programmable xBee is high

0 votes
I have a Programmable XBee-PRO ZB. The manual specifies a combined usage of 4uA (3.5uA + 0.5uA) for the package. I can't get it to use less than 350uA.

Things I have tried/set:
- pm_set_radio_mode(PM_MODE_STOP);
- pm_set_cpu_mode(PM_MODE_STOP, WAIT_INFINITE);
- Power management enable low voltage detection set to false
- Keep uptime set to false
- All unused pins set to output with pull down set to false

I could use some suggestions.
asked Nov 6, 2014 in XBee Programmable Development by raymond.kurzweil New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Check the PR parameter.
answered Nov 11, 2014 by mvut Veteran of the Digi Community (12,765 points)
...