Home/Support/Support Forum/Could not send the frame > Special byte not escaped: 013x
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Could not send the frame > Special byte not escaped: 013x

+1 vote
Problem category: XCTU
All Xbee were set to AP=2.

XCTU on MAC OSX 10.9.5
on Console, and frames are defined.
The frame generator automatically modified XBee address (high) from "0013A200" to "007D33A200".

(1) click "Send a single frame" ---> could send
(2) click "Start Sequence" ---> error message "Could not send the frame > Special byte not escaped: 013x" was shown

Any suggestions are welcome.
Thank you.


cf) XCTU on Windows 8.1 works well for both cases.
against the same frames as above.
(3) click "Send a single frame" ---> could send
(4) click "Start Sequence" ---> could send
asked Nov 11, 2014 in Other/Legacy by hiron New to the Community (1 point)
Same exact issue on my mac, 10.10.1 with the following version of X-CTU
Version: 6.1.2
Build ID: 20140916-3

Please log in or register to answer this question.

...