Home/Support/Support Forum/how to congigure xbee series 1 to support multiple point-to-multipoint communication.

how to congigure xbee series 1 to support multiple point-to-multipoint communication.

0 votes
Dear All,

I have 4 xbees series 1. I want to design a project that 3 of those xbees will be connected directly to analog sensors (a microcontroller will not be used) and the xbees should send the data, collected from the sensors, to the base. The base being a xbee connected to arduino YUN. Could you please help me configure the xbees? Should I enable the API mode for all xbees? The base xbee should be set to act as coordinator and the others as end devices?

Your help would be appreciated.
asked Nov 24, 2014 in IEEE 802.15.4 by Yasser Khalil New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
I would suggest configuring them as described at http://www.digi.com/support/kbase/kbaseresultdetl?id=2180.
answered Nov 24, 2014 by mvut Veteran of the Digi Community (12,302 points)
would you please again suggest that page link? As it is updated and is difficult to pick the right one.
...