Home/Support/Support Forum/XBee S2B Pro Sample Rate Question

XBee S2B Pro Sample Rate Question

0 votes
I'm having an issue with S2B Pro IR Sample Rate.

I've set the IR Sample Rate to "0x32", this means a 50ms IR Sample Rate or 20Hz.
Baud Rate is set to 9600.

I have a 3-axis analog accelerometer plugged into three different XBee ports, set as analog.

After I read the data I get 14 samples per sec instead of the 20 I was hoping for.
I understand I am doing something wrong, can't seem to find where is the issue.

Thanks in advance,
asked Dec 7, 2014 in XCTU by Simaoms New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Could be a throughput issue. The mesh based products are not well suited for streaming data. Try telling the system to transmit after taking two samples.
answered Dec 10, 2014 by mvut Veteran of the Digi Community (15,320 points)