Home/Support/Support Forum/How to configure the DIGI IA RealPort based on the below requirements?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How to configure the DIGI IA RealPort based on the below requirements?

0 votes
Dear Support,

Please, be informed that we have some DIGI with P# 70001862.
Each one is connected to 8 slave devices (RS-485/422, 4 wire), and on the Ethernet port it's connected to SCADA system by Modbus TCP/IT.

Could you please send me the required configuration to success this communication.

Appreciate your prompt reply whereas we are in the commissioning stage.

Regards,

Fuad AL-Enbawi
EEIC/KSA
Automation Engineer
asked Dec 9, 2014 in Realport by Fuad AL-Enbawi New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
The following might be useful:

http://www.digi.com/support/kbase/kbaseresultdetl?id=891
answered Dec 10, 2014 by userid0 Veteran of the Digi Community (2,158 points)
selected Dec 11, 2014 by Fuad AL-Enbawi
...