Home/Support/Support Forum/How send command of Node Discovery in XBEE 900HP in Matlab?

How send command of Node Discovery in XBEE 900HP in Matlab?

0 votes
asked Dec 12, 2014 in IEEE 802.15.4 by thiago_liveira New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
You do it just like you would in XCTU or Hyper Terminal or any other serial application. You open the COM port, Wait the guard time of silence, issue +++, wait the guard time of silence. Then issue the ATND command. At which point you switch from doing a serial write to a serial Read.
answered Dec 12, 2014 by mvut Veteran of the Digi Community (15,225 points)
0 votes
I used to send this in matlab.
answered Feb 4, 2015 by thiago_liveira New to the Community (1 point)
...