Home/Support/Support Forum/How do I factory reset XBP24-AWI-080 manually?

How do I factory reset XBP24-AWI-080 manually?

0 votes
Hey, I bought some Series 1 XBP24-AWI-080 modules used from a wholesaler with unknown settings. I was not able to connect it via. XCTU and USB through gateway mode.

Afterwards, I connect it with remote programming using an outside Series 1 module and it says in sleep mode.

IS there any way I can reset the module to factory settings through the physical layer (ie. apply a voltage to a pin). I have no way to know the initial settings of the module.

If not, can you please explain how to connect my XBP24-API-001 module to remotely program the XBP24-AWI-080?

I know they are different models, but they are both series 1 and accept AT commands to my knowledge. The problem is that XCTU says the remote device cannot be initialized.
asked Dec 13, 2014 in RF Solutions and XBee by 0xda71d New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Try following the steps outlined at https://www.youtube.com/watch?v=fxOqQZD-oaM.
answered Dec 16, 2014 by mvut Veteran of the Digi Community (13,094 points)
...