Home/Support/Support Forum/How to display diagnostic messages?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How to display diagnostic messages?

0 votes
hi,

thank you very much for your answer,
On ECLIPSE,I have completed the steps you've told me, I built the firmware image, then, I uploaded it to target device via ftp.
Finally I interfaced to NET + OS via telnet, I see a thread "UdpDebugThread" turns ..
For cons, I do not get diagnostic messages!
Can you please tell me the command or the manipulation that can do it?

thank you,
related to an answer for: Debug remotely without using the JTAG LINK
asked Dec 18, 2014 in NET+OS by slah07 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You don't say much about the PC side so I may be stating things you already know, as follows:

In the directory where you installed NET+OS is a directory entitled bin. (from a DOS shell) cd to <your top level NET+OS directory>\bin. Find file udpdb. Run udpdb. run it as follows:

udpdb <ip address of your module>

I believe the module needs to be up and the port open before running udpdb
answered Dec 18, 2014 by dakotas_dad Veteran of the Digi Community (694 points)
...