Home/Support/Support Forum/XBee S2 Analog Pin Readings

XBee S2 Analog Pin Readings

0 votes
I have 2 XBee S2 routers. The settings for Analog Pins 0 thru 3 are set to ADC [2]. One XBees is mounted on a Jaycon Systems explorer board and the other on an adapter board.

Currently I have nothing attached to the sensor pins, just configured. The samples for the pins are all coming into my Netduino as follows:

Analog Pin 0 0211 = ( 529 0.62052785923753662 )
Analog Pin 1 0210 = ( 528 0.61935483870967745 )
Analog Pin 2 020E = ( 526 0.61700879765395888 )
Analog Pin 3 020F = ( 527 0.61818181818181817 )

I was expecting them to be 0 since nothing is connected.
Am I missing something in my understanding here? I am afraid to connect sensors in that I might send too much voltage & burn out the pins.
Thanks for your thoughts.
asked Jan 5, 2015 in DigiMesh Proprietary Mesh Networking by tottka01 New to the Community (5 points)

Please log in or register to answer this question.

3 Answers

0 votes
That would indicate that you are getting voltage on the lines. Regardless of what you think.
answered Jan 6, 2015 by mvut Veteran of the Digi Community (11,302 points)
0 votes
Is that normal for the adapter boards to do this?
answered Jan 6, 2015 by tottka01 New to the Community (5 points)
0 votes
If the analog inputs are not connected they may float. You should connect them to GND your ADC should read 0x00. If you connect them to VCC your ADC should read 0x3FF.
answered Nov 2, 2015 by AndyDale New to the Community (10 points)
...