Home/Support/Support Forum/Set remote PWM

Set remote PWM

0 votes
Using XBee series 1 modules I can set a PWM output using an AT command (ATPn to configure, ATMn to set a value) on the local module, but not a remote one.
Using XBee series 2 modules I can execute an AT command on a remote module, but there is now no AT command to set a PWM output.
How can I set a remote module's PWM output without resorting to passing an ADC input i.e. by command OTA?

Thanks
Matt
asked Jan 22, 2008 in IEEE 802.15.4 by mdknight New to the Community (3 points)

Please log in or register to answer this question.

...