Home/Support/Support Forum/How can I troubleshoot a Link between 2 XBee-868-Pro
New and improved user forum site coming soon

How can I troubleshoot a Link between 2 XBee-868-Pro

0 votes
I have one Xbee connected to the PC (XTCU) and the other one connected to a host processor.
Both of them are in API Escaped Mode.
The other parameters are on default. ID is 0x7FFF.
I can send AT(08) commands to both of them.
But I cannot discover the other one.
Sometimes the other one is discovered , but is described
as in Sleepmode (SM=0, should not occur).

Please give some hints.
asked Feb 19, 2015 in RF Solutions and XBee by Bummibaer New to the Community (5 points)

Please log in or register to answer this question.

2 Answers

0 votes
What is the API frame you are using to Discover the other radio?

What happens if you use a mixture of transparent mode and API mode between the two?
answered Feb 25, 2015 by mvut Veteran of the Digi Community (15,515 points)
0 votes
hi mvut,

I'm using API2 and XTCU 6.1.2.
I'm still experiencing this behavior. How can I debug this.
XTCU is waiting in
"Discovery remote devices..."

Uups, during my writing, it discovered my device. How long, I have to wait at least? For minutes?

Is there any document to describe the process?


My configuration is like this:
Your text to link here...
answered Mar 4, 2015 by Bummibaer New to the Community (5 points)
I've just read in the xbee-arduino-project, that the XBee after HW_Reset or Wake-UP:
when XBee powers up it sends a modem status 0 (hardware reset), followed by a 2 (Joined Network), assumming it's configured correctly
// when XBee is woken up it sends a modem status 2 (Joined Network)

At me, only the modem status 0 is received, why? When will the Joined
Network will be send?