Home/Support/Support Forum/Xtend repeater mode

Xtend repeater mode

0 votes
then I must configure the master radio with MD = 6, the repeater MD = 5 and the end nodes MD = 6 ??

And the radios that communicate directly with the master radio, must also configure MD = 6 or should I configure MD = 0??
related to an answer for: 9XTend Repeater Configuration Question
asked Feb 19, 2015 in RF Solutions and XBee by Adriano Silva New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
In a repeater network, the base and farthest node out are MD 6 (Repeater End Node). The Repeater is MD 5. If there are more node and they are in range of the base, then they will use MD 6 as well. All radios must have a unique MY value.
answered Feb 25, 2015 by mvut Veteran of the Digi Community (11,852 points)
...