Home/Support/Support Forum/How do I get proper 'help' response after setting up XIG with XBee and Connectport X2?

How do I get proper 'help' response after setting up XIG with XBee and Connectport X2?

0 votes
I am following the procedure from "Building Wireless Sensor Networks", and the ATAI and ATND commands respond fine, but I get no response when sending 'help' through serial port. Any advice?
asked Feb 26, 2015 in ZigBee PRO Featureset (and legacy ZNet 2.5) by jphilli New to the Community (0 points)

Please log in or register to answer this question.

...