Home/Support/Support Forum/unable to configure the s2 module as znet2.5 router/end device AT in xctu 6.1.0

unable to configure the s2 module as znet2.5 router/end device AT in xctu 6.1.0

0 votes
i'm unable to configure my xbee s2 module as ZNET2.5 router/end device AT in X-ctu 6.1.0. when i try to do so it is writing the firmware but at the end(while reading the parameters) it is showing the error message as " Could not find any device in port COM5 > Error initializing XBee device parameters > Connection timeout."

but i could configure the other configurations such as ZNET2.5 router/end device API , Zigbee router/end device AT. there was no problem with these configurations.

can someone help me out....!
asked Mar 23, 2015 in XCTU by sekhar New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
The Znet 2.5 code is no longer support and has been for a few years. As such, I would not expect a product shuch as XCTU NG to support a product or Code that has not been supported for 3 to 4 years.
answered Mar 25, 2015 by mvut Veteran of the Digi Community (12,779 points)
...