Home/Support/Support Forum/Xbee S1, accidentally plug the IO0 (pin 20) and the IO4 (pin11) to VCC (3.3V) and GND.I broken my Xbee?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Xbee S1, accidentally plug the IO0 (pin 20) and the IO4 (pin11) to VCC (3.3V) and GND.I broken my Xbee?

0 votes
asked Apr 1, 2015 in RF Solutions and XBee by francescoermini New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
No you have not as both pins are designed to accept 0 and 3V VCC.
answered Apr 3, 2015 by mvut Veteran of the Digi Community (15,156 points)
Right, Thanks for reply! I got suspicious because my Xbee seemed to be dead but I discovered  that it was only a bad contact between the Xbee and the pin header, due to a manufactory problem on the pin header.  I confirm that 3.3V on pin 20 don't damage the Xbee.
commented Apr 5, 2015 by francescoermini New to the Community (0 points)
...