Home/Support/Support Forum/is dnp 3.0 supported by digi transport wr44 through serial?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

is dnp 3.0 supported by digi transport wr44 through serial?

0 votes
I am having trouble receiving data from a remote RTU via DNP . where under management under connections tab, it will show my servers IP connected to it but will not receive any data from the RTU, but will receive data via ASKII.
Does the WR44 support DNP through the Serial port? if so what will be best way to setup?

asked Apr 2, 2015 in Digi TransPort Cellular by rchavarria New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Do you poll the RTU from the outside? If so, configure your WR44 serial port to listen on port 20000. If the RTU initiates the connection (very odd that it would), then set the outbound port to 20000. You should be able to use the Serial Port Wizard to set this up.
answered Mar 2, 2016 by billw1 Community Contributor (56 points)