I have 3 xtend OEM RF modules with digimesh firmware (8064). I'm not too sure if I correctly set up one of the xtend to be a repeater and not sure how to check since I'm not able to do a field test. My goal as of now is pretty simple, I have an xtend sending a message to be repeated to the other xtend module. Or in other words a directed broadcast with a repeater. I'm using two computers with XCTU for the end devices and a micro-controller hooked up to the module as the repeater. BTW I'm using API mode 2 to message between each end node.
For the repeater my settings are CE = 0 (Routing), T0 =0x80 (repeater/directed broadcast). DH = 0 and DL =FFFF.
As for the other two xtend I've set them to END devices (CE= 1) and T0 = C0 (digimesh)
I've set the END devices DH and DL (Destination) to match each others SH and SL (Serial number) parameters.
So when I sent a TX request 64-bit address frame the message gets through but I'm not sure if the repeater did anything. This would be easier if I was able to do a field test but cannot at the moment.