Home/Support/Support Forum/xbee zb bat L/T/H is not powering on

xbee zb bat L/T/H is not powering on

0 votes
I tried to upgrade the firmware of Xbee2 LTH sensor. When the upgrade was in progress the XCTU get restarted. Now the LTH sensor is not powering ON. Please help?
asked Apr 20, 2015 in XBee Programmable Development by pathakhcst New to the Community (4 points)

Please log in or register to answer this question.

1 Answer

+1 vote
You are going to need to remove the XBee module from the LTH sensor and mount it on an XBIB board. Then you can re-flash the firmware to the radio.
answered Apr 21, 2015 by mvut Veteran of the Digi Community (15,320 points)