Home/Support/Support Forum/Xbee s2 sending problems

Xbee s2 sending problems

0 votes
I am currently trying to send analog datas from sensors connected to xbee serie 2 devices. Datas are retrieved by a Raspberry Pi.

At the moment, I want the xbee (AT end device configured) to send what it is reading on its AD0 input (pin 20) to the other xbee (AT coordinator configured).
I can see that they are communicating each other (RSSI ans ASSOC are on). BUT I cannot have the data at the coordinator point.
I already checked again my configurations and they're right. Do I need to configure them on API mode?
If not, what can be the problem?

Thanks in advance.
asked Apr 20, 2015 in RF Solutions and XBee by PTrans Polytech New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
ALL ADC communications requires that the module receiving the ADC data and to output it on its UART must be in API mode..
answered Apr 21, 2015 by mvut Veteran of the Digi Community (11,302 points)
...