Home/Support/Support Forum/set the xBee-s2 to Zigbee router sensor and then can't connect to it with X-CTU
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

set the xBee-s2 to Zigbee router sensor and then can't connect to it with X-CTU

0 votes
I set the xBee-s2 to Zigbee router sensor and then I can;t communicate with it. I have tried to reset and recovery it, but it doesn't work.
asked Apr 21, 2015 in IEEE 802.15.4 by poptoplcy New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Take help of this KB article:
http://www.digi.com/support/kbase/kbaseresultdetl?id=3402

you will need a interface board with hardware flow control lines present (eg. Digi XBIB board). If not, then first optimize USB settings of system before attempting recovery:
http://www.digi.com/support/kbase/kbaseresultdetl?id=3418
answered Apr 22, 2015 by asgm Veteran of the Digi Community (1,499 points)
The reason for this is that the firmware version you selected disables the UART on the radio. You must use the recovery function or an OTA update to change the code after this occurs.
commented May 13, 2015 by mvut Veteran of the Digi Community (15,410 points)
...