Home/Support/Support Forum/Port Server TS: 0xFF characters are being doubled in Raw TCP/IP mode
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Port Server TS: 0xFF characters are being doubled in Raw TCP/IP mode

0 votes
When using a Port Server TS in Raw TCP/IP mode from a Linux Host running a binary protocol (here SEMI E4 - SECS-I) characters of value 0xFF sent from an Equipment are sent twice to the host. This has been seen with Firmware 82000747_U and 82000747_W. The doubled characters are also logged when Port Logging is enabled.

Using the same Port Server with a RealPort Driver from a Windows Host does not exihibit this problem. The Port Server System mode is set to Latency.

Is there a setting to circumvent this? Or can this be a Firmware Bug?
asked May 26, 2015 in Portserver TS by GStegemann New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
You will want to take a look at the input processing flags for the port(s):

# ditty-rp -a ttyxyz

ignbrk, brkint, ignpar, parmrk, inpck, istrip, inlcr, igncr, icrnl,

In most cases these should be off (-).

Also, parity (checking) may impact this, as well. You will want to look over your parity configuration on the port and attached device.
answered May 27, 2015 by userid0 Veteran of the Digi Community (2,158 points)
Thanks, that's the trick.

Unfortunately these settings are not visible on the port Servers Web Interface.
...