Home/Support/Support Forum/Xbee S8 868LP DPUS Sleep Option (ATSO)

Xbee S8 868LP DPUS Sleep Option (ATSO)

0 votes
Hello Digi-Forum users,

I have a problem concerning a 868LP DPUS module (10k variant).
I have updated the firmware to the latest version (1074), however response to the ATSO1(0x02) command keeps saying "ERROR".

Is this command only valid for digimesh enabled modules? I have a 868LP DMUS modules which do not suffer from this problem.

Also, can somebody confirm that digimesh is NOT available on a 10k (868LP DPUS) module?

Best regards,

Sander
asked May 27, 2015 in DigiMesh Proprietary Mesh Networking by hummus New to the Community (0 points)
edited May 27, 2015 by hummus

Please log in or register to answer this question.

1 Answer

0 votes
First that is correct. Digi Mesh is not available on the 10K code.

Next, what is the actual SO command you are providing? The value for this command is actually Hex and not ASCII. So if you want to set it to 2, you would issue an ATSO02.
answered May 29, 2015 by mvut Veteran of the Digi Community (12,351 points)
...