Home/Support/Support Forum/Xbee S2 API mode help

Xbee S2 API mode help

0 votes
Hi friends

I'm trying to do a couple of Xbees communicate in AT mode, I could already operate.
Now I'm trying to make them work in API mode, but I can not make the circuit attached.
They "see" the network, but when I press the power button, nothing happens ...
One would have any idea what might be wrong with my setup?

Follows the circuit and settings of each module.

https://www.dropbox.com/s/szwrsouyau90sel/Xbee%20question.jpg?dl=0

thank you very much
asked Jun 4, 2015 in XBee Programmable Development by Acruwer New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
Yes, the product you are using does not support DIO line passing. You need to use the XBee 802.15.4 modules for DIO line passing.
answered Jun 9, 2015 by mvut Veteran of the Digi Community (11,300 points)
0 votes
Thanks friend!
answered Jun 9, 2015 by Acruwer New to the Community (1 point)
...