Home/Support/Support Forum/Interpreting Cellular & Signal Strength LEDs on CP X4

Interpreting Cellular & Signal Strength LEDs on CP X4

0 votes
asked Jun 10, 2015 in RF Solutions and XBee by mcarangi New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
SIGNAL STRENGTH: Indicated relative signal strength where:

– 0 LEDs: Unacceptable; Signal strength is very weak or not detectable
– 1 LED: Weak
– 2 LEDs: Moderate
– 3 LEDs: Good
– 4: LEDs: Excellent

Not very detailed, however, the exact RSSI value can be obtained via the WebUI Information > Mobile page or via the "display mobile" CLI command.
answered Jun 16, 2015 by userid0 Veteran of the Digi Community (2,158 points)