Home/Support/Support Forum/hi ı want to create sensor mesh network with three xbees2 as one of coordinator,one of router,one of end device?

hi ı want to create sensor mesh network with three xbees2 as one of coordinator,one of router,one of end device?

0 votes
ı confıgured xbees using with x-ctu as;
Coordinator;
Firmware:zigbee coordnator apı
PAN ID:0
SCAN CHANNELS:1FFE
OP ID:799142BCC8A(automatşcally assigned)
ch:7(automatşcally assigned)
sh:13a200
sl:40e66e4f
my:0(automatic)
dh:0
dl:ffff
apı:1
router
Firmware:zigbee router at
PAN ID:0
SCAN CHANNELS:1FFE
OP ID:0(automatşcally assigned)
ch:0(automatşcally assigned)
sh:13a200
sl:40cc0046
my:fffe(automatic)
dh:13a200
dl:40e66e4f
d3:adc
ır:64
end device
Firmware:zigbee end device at
PAN ID:0
SCAN CHANNELS:1FFE
OP ID:0(automatşcally assigned)
ch:0(automatşcally assigned)
sh:13a200
sl:40cc015b
my:fffe(automatic)
dh:13a200
dl:40c0046
d2:adc
ır:64
cycle sleep mode

ın this confıuration,there are one sensor in router and end device.ı took apı frame from router but ı didnt take apı frame from end devide.router cant send the end device ınformatıon.
How can you solve this situation?
asked Jun 12, 2015 in ZNet 2.5 by mhbalaman New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
Are you using hardware flow control on the End device and your device connected to the end device?
answered Jun 12, 2015 by mvut Veteran of the Digi Community (11,300 points)
0 votes
ı made cts flow control form digital pın in end device.End devic only connected to sensor.
answered Jun 15, 2015 by mhbalaman New to the Community (1 point)
...