Home/Support/Support Forum/Error writing for AT parameters while configuring Xbee S6B module

Error writing for AT parameters while configuring Xbee S6B module

0 votes
I'm trying to configure Xbee S6B, but I'm getting
Error writing the following AT parameters
-GW: status error
-MK: status error
-MY: status error

How to solve this problem
asked Jun 14, 2015 in IEEE 802.11 (Wi-Fi) by vsnkumar New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
What version of Firmware are you working with? How are you writing these parameters?
answered Jun 15, 2015 by mvut Veteran of the Digi Community (12,302 points)
0 votes
I'm trying to configure Xbee S6B (Firmware 2021) with XTCU, but I'm getting yhe next message:
Error writing the following AT parameters

-GW: status error
-MK: status error
-MY: status error

Parameter MA is DHCP.

If I change to static and write I can write GW, MK and MY too. But if I change MA to DHCO again then GW, MK and MY are set to 0.0.0.0
answered Nov 18, 2015 by hoscar New to the Community (1 point)
...