Home/Support/Support Forum/How can I configure xbee s2 in point to multipoint network using AT mode?

How can I configure xbee s2 in point to multipoint network using AT mode?

0 votes
asked Jun 17, 2015 in RF Solutions and XBee by sam__ New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
That is the default configuration of the XBee ZB modules. That is to say, by default the coordinator will broadcast all data out to all other nodes within the network while all other nodes will be configured as a Unicast connection back to the Coordinator.
answered Jun 17, 2015 by mvut Veteran of the Digi Community (12,302 points)
...