I have my first two nodes setup, I have a ZigBee Coordinator API module and a ZigBee End Device API module. I have the end point connected on Analog pins 1-3 with sensors for temp, moisture, and light.
I have the pins D1-3 configured for ADC, and the IR sample rate setting at EA60 for once per 60 seconds.
The frames log on the co-ordinator shows a stream of Explicit RX Indicator frames and Transmit Status frames, but I am seeing no IO Data Sample RX Indicator frames.
Also, I wired an LED to the sleep indicator pin, and it is almost constantly lit, it's certainly not sleeping for a minute at a time.
Any help would be greatly appreciated.