Home/Support/Support Forum/digimesh network

digimesh network

0 votes
hi, ı want to create a mesh network with xbee.I needed 6 analog channel for my project but xbee series 2 have only 4 analog channel.I think that ı can use xbee series1 with digimesh network with firmware or ı can use a mux to increase analog channel of xbee series.Which way is more preferable for xbee project
asked Jun 24, 2015 in DigiMesh Proprietary Mesh Networking by mhbalaman New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
First off, why Mesh? Are you working in an area where you are unable to obtain the necessary connection over a Point to point, or Point to multi-point connection? If not, then I would just use the 802.15.4 modules.

Next, If the XBee module that best fits your application does not have all of the required ADC lines, I would consider using an external processor or uC to either support all of the ADC lines needed or to offset what lines I do not have enough of.
answered Jun 26, 2015 by mvut Veteran of the Digi Community (11,302 points)
...