Home/Support/Support Forum/XBee S6B WiFi AT DB Command for RSSI

XBee S6B WiFi AT DB Command for RSSI

0 votes
I'm running the AT "DB" Command for RSSI of the Access Point for a XBee S6B in Client Mode.

The command I run is:
char ACCESS_POINT_SIGNAL_QUALITY[] = { 0x7E , 0x00 , 0x04 , 0x08 , 0x01 , 0x44 , 0x42 , 0x70 };

This matches X-CTU's Frames Generator:
7E 00 04 08 01 44 42 70

I successfully run quite a few other AT commands with the same code interface but the DB command always gives me a 0x02 status or "Invalid Command".

When I run the command, the XBee is connected to my router and can send and receive TCP packets.

What is happening here? Why do I get Invalid Command for this particular AT commad?
asked Jul 14, 2015 in IEEE 802.11 (Wi-Fi) by PhilBee New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
PS I updated to the latest Firmware and still get 'Invalid Command'.
answered Jul 16, 2015 by PhilBee New to the Community (2 points)
...