I'm trying to do a simple test with the XBee S6B (PCB Antenna-Through Hole) chip before integrating it into a larger device.
I want to be able to "ping" the XBee Chip, and have an LED blink when it receives the command, and then another LED blink when it replies.
So far, I can ping the XBee and get replies. The trouble comes with getting the LED's to blink. See photo link below of the circuit that I've built.
Link: XBee-S6B LED Ping Test Schematic
The Associate LED (LED1), blinks as expected. Indicating that I am connected to my Wifi Network. However, the other 2 LED's stays on constantly, and does not blink with ping's.
Any help would be much appreciated, thanks.