Home/Support/Support Forum/how to configure digimesh 2.4 for at least 5 nodes in mesh network ??

how to configure digimesh 2.4 for at least 5 nodes in mesh network ??

0 votes
hey
i am beginner in digimesh...

i want to make mesh network of 5 nodes which aggregate data to one different module.

plz give step wise process to configure each digimesh 2.4 modules using XCTU.



and also suggest me how to check mesh network on Xctu software (like terminal etc.)
asked Aug 10, 2015 in DigiMesh Proprietary Mesh Networking by ankitmail1993 New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

+1 vote
The best way to do this is to configure the radios in a classic point to multi-point configuration, then send your data.

Base:
DH 0x00
DL 0xFFFF

Remote (s)
DL = SL of base
DH = SH of base


Test this by sending data back and forth and moving nodes till they are out of range. Than move back till it is in range and add one as a router at that location. Then keep going farther out.
answered Aug 10, 2015 by mvut Veteran of the Digi Community (11,302 points)
this is star topology ....

in this REMOTES are not communicated with each other..

i want to create MESH network
The configuration is the same but the modules are different. A Mesh module will figure out how to get the data from the Sending unit to the receiving unit on their own where as the Non mesh modules required the sending unit to be in range of the receiving unit.
...