Home/Support/Support Forum/xbee s1 xctu arduino

xbee s1 xctu arduino

0 votes
Hello u all,

Please i just cant find my xbee module in the XCTU while using an arduino + Sparkfun XBEE shield + XBEE S1.

It just keep asking me to reset my module. When i do reset the xbee shield nothing happens.

My shield is with the pwr led on and the DIO5 let blinking (When theres a Xbee on the shield)

Thx in advance.
asked Aug 13, 2015 in XCTU by felipegatti1 New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
The shield is not design for writing and reading firmware to and from the XBee module. It is only designed for basic two way communications. If you want to read or write firmware to the module, you need to use a board that is designed for it such as the XBIB boards from Digi.
answered Aug 31, 2015 by mvut Veteran of the Digi Community (12,786 points)
0 votes
I too have this situation. I am new to XBee radio modules.
It has been suggested to configure both XBees on my Explorer USB. I am a bit confused as to the answer given below.
Should I accept that XCTU cannot detect an XBee S1 mounted
on a SparkFun XBee Shield/Arduino UNO?
answered Mar 24, 2017 by GeorgeG New to the Community (1 point)
XCTU cannot find the XBee if it is mounted on your Arduino, unless you've programmed your Arduino with some sort of serial passthrough code