Home/Support/Support Forum/How to check S6B antenna output

How to check S6B antenna output

0 votes

I have a problem with a S6B unit. I have the strong suspect that it's damaged (a DoA eventually) and it's not able to locate any network in the area. How can I check it to be sure about what failure I run into?

Best regards,
asked Aug 14, 2015 in IEEE 802.11 (Wi-Fi) by weirdgyn New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
Try restoring two of them to defaults and issuing a network reset. Then set them up as Soft AP mode and see if it works or not.
answered Aug 31, 2015 by mvut Veteran of the Digi Community (12,302 points)