Home/Support/Support Forum/Coordinator does not respond to many-to-one request

Coordinator does not respond to many-to-one request

0 votes
My network consists of 1 coordinator, 10 or so routers and 50 or so end devices.

I am using a mixture of many-to-one and source routing to control most of the network from one of the routers.

When I first setup the network the coordinator would respond to many-to-one route requests. Now it does not do so. I've done a power reset and updated some settings, but this does not affect whether it responds.

Is this expected behavior? Seems that this should respond to the many-to-one (AR) requests).
asked Sep 8, 2015 in IEEE 802.15.4 by hwestbrook New to the Community (5 points)
edited Sep 7, 2015 by hwestbrook

Please log in or register to answer this question.

1 Answer

0 votes
Best answer
Sounds like the Coordinator is not on your network or you are not issuing the AR command that often. To resolve, try issuing a network reset with a 1 and then re-issue the AR command.
answered Sep 10, 2015 by mvut Veteran of the Digi Community (11,300 points)
selected Sep 22, 2015 by hwestbrook