Home/Support/Support Forum/Is there a configuration sample to Xbee Pro 900 Digimesh S3B?

Is there a configuration sample to Xbee Pro 900 Digimesh S3B?

0 votes
asked Sep 23, 2015 in DigiMesh Proprietary Mesh Networking by Alexandre Fonseca New to the Community (1 point)

Please log in or register to answer this question.

3 Answers

0 votes
What kind of sample are you looking for. They are designed so that they will communicate right out of the box.
answered Sep 23, 2015 by mvut Veteran of the Digi Community (11,298 points)
0 votes
I want to make a simple communication. I'm trying to communicate without an antenna. is there any problem to power on XBee RPSMA without antenna?
answered Sep 23, 2015 by Alexandre Fonseca New to the Community (1 point)
Yes, you do need to have antennas on them.   If you follow the Quick start guide, it will have you communicating in less than 5 min.
May I use a 2.4 GHz antenna just for a test?
It is not recommended but a mismatched antenna is better than no antenna.   Just understand that it may not perform as well.
with an antenna it's working well.
0 votes
what the configuration u used to make communication two way between four arduino over xbee
answered Sep 5, 2017 by dania_alkhateeb New to the Community (3 points)
...