Home/Support/Support Forum/why sleep current is high
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

why sleep current is high

0 votes
i just configure the end device as follows..
SP=1F4*10=5000msec=5sec
ST=1388(hex)=5 sec
IR=1388(hex)=5sec
i didn't put any application running on the XBee .
when the end device is in the network and when it is in sleeping mode it is taking 5.6mA??
why it is taking 5.6mA??
practically it has to take less than 10 micro amperes..
what might be the problem?? :( :(
asked Oct 1, 2015 in ZigBee Smart Energy Profile 1.1 by subbanarasaiah New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
That is most likely the result of the PR or Pull-up resistor command. Try Disabling any pull-ups that are on unused lines. You should see the current reduce.
answered Oct 1, 2015 by mvut Veteran of the Digi Community (14,297 points)
Thanks for your reply..
I just made it as you said I made PR=0 since I am not using any pins but even then I am getting value as 5.5mA ??? What might be the problem??
commented Oct 1, 2015 by subbanarasaiah New to the Community (1 point)
I would now start looking at what lines are set to what values and set any unused lines as an output low.
commented Oct 1, 2015 by mvut Veteran of the Digi Community (14,297 points)
...