Home/Support/Support Forum/How can I tell if there is active equipment on CM ports.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How can I tell if there is active equipment on CM ports.

0 votes
asked Oct 14, 2015 in Console Servers by jureynolds New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
You might be able to tell by looking at the active serial signals under the Serial statistics > Serial Ports menu from the Digi CM web interface.
answered Oct 15, 2015 by userid0 Veteran of the Digi Community (2,158 points)
0 votes
Via the CM web ui under: System stat->Serial ports it shows signal status and data in (Rx) and data out (Tx)
answered Oct 15, 2015 by ronk Seasoned Professional (206 points)
I don't have these options, only thing I see is serial port, clustering, system administration.
commented Oct 15, 2015 by jureynolds New to the Community (0 points)
The "System statistics->Serial ports" pg has been there since day 1 of the CM.  On left side below "System adm".  Sure this is a CM ?  We can verify by serial number.  Firmware rev would also help?
commented Oct 15, 2015 by ronk Seasoned Professional (206 points)
...