Home/Support/Support Forum/Xbee 868LP to XCTU 6.2 no answer

Xbee 868LP to XCTU 6.2 no answer

+1 vote
Hello,

i want am connect a Xbee 868 (XB8-DMUSB002) with XCTU 6.2 over a FTDI-Cable (http://www.ftdichip.com/Support/Documents/DataSheets/Cables/DS_TTL-232RG_CABLES.pdf). Unfortunately I get no response from the module if i add a module over XCTU. what is the bug?

Hardware connection:
PIN1 --> GND
PIN2 --> 3,3VDC
PIN3 --> FTDI-RXD
PIN4 --> FTDI-TXD

Trace on COM5:
send:
~....APe+++AT.
(7E 00 04 08 01 41 50 65 2B 2B 2B 41 54 0D )

reply:
nothing :blue:

thanks for your support
Andre
asked Oct 20, 2015 in DigiMesh Proprietary Mesh Networking by keflex87 New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
That is NOT a standard XBee 868 LP module. That is a Programmable module. Which means that it has a 2nd processor on board which you Must write and upload code to via a BDM programmer before it will do anything.
answered Oct 21, 2015 by mvut Veteran of the Digi Community (11,302 points)
...