Home/Support/Support Forum/flashing a programmable bootloader to XBee
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

flashing a programmable bootloader to XBee

0 votes
currently I am working with XBee PROS2B.
how can we make an XBee device to a programmable one??
is it possible through XCTU??
what are the steps required??
how can we see boot loader menu commands for XBee ??
currently I am unable to see through XCTU:(:(
thanks in advance.
asked Oct 27, 2015 in XBee Programmable Development by subbanarasaiah New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

+1 vote
That is not something you can simply do with XCTU. A programmable XBee module has a 2nd processor added to the XBee PCB that is between the Pins and the RF processor.
answered Oct 27, 2015 by mvut Veteran of the Digi Community (15,355 points)
hello mvut,
thanks for your reply.
presently I am doing like what they told in the XBee SDK Documentation by using code warrior.
and when I am flashing the binary file to the target(XBee PROS2B) it is not showing the device connected to the port.
may I know how can we add a device to flash a binary file on to it?
will you tell me the process how to make a XBee a programmable one
looking forward to your reply
thanks in advance
commented Oct 28, 2015 by subbanarasaiah New to the Community (1 point)
A Customer Does not make a standard Xbee or Xbee PRO a Programmable XBee.  That process must be done in the factory as the modules PCB is produced.
commented Oct 28, 2015 by mvut Veteran of the Digi Community (15,355 points)
...